ZS6BKW Center Fed Antenna, 80-6 Meters, 500/1.5KW/5KW PEP rated - FREE shipping in USAProduct DetailsBrand: Palomar EngineersFrequency Band(s): 80-6Country/Region of Manufacture: USAFreq Range (MHz):: 3.5-54 MhzPower (PEP watts):: 500/1500/5000Length (ft):: 88 feet Wire and 40 feet Ladder LineExcellent features:
*** Covers 40-20-17-12-10 meter ham bands under 2:1 at most heights no tuner required, 80, 15, 6 meter bands require wide range tuner
*** Great digital/FT8 antenna on many bands without tuner
*** Low SWR on many bands or use antenna tuner
*** 500 watts/1.5KW/5KW PEP (SSB-ICAS) options
*** Stainless Steel hardware for long life
*** Halyard Hoist hole for ease of center support installation or hang at ends only
*** Insulated #14 wire for durability
*** High Strength insulators (may be black, white or gray)
*** Ladder Line to 1:1 Balun (Note 1500/5000 Watts CUBE Balun can be mounted to a wall, 500 watts MB-1-500 is supported by ladder line
Super convenient and quick – great for contest operation! Choose 500, 1500 or 5000 watt PEP (use 5KW model for digital modes over 1000 watts).
INSTALLATION
For best results support center at 30+ feet and ends over 15 feet. Angle of feed each side must be great than 45 degrees or 120 – 180 degrees total between each side preferred. Any length of 50 ohm feed line ok (from the matching unit) but longer feed lines over 50 feet may show reduced SWR on some bands due to losses in feed line and soil conductivity, nearby objects, etc. Due to local ground conditions, antenna height and feed line length, SWR may vary from samples shown and an antenna tuner may be required or some bands to bring SWR at end of feed line to acceptable levels.
Antenna Length Note:These antennas are shipped from the factory with each side at 46 feet long (92 feet total) so that you may adjust(shorten) the length for your personal installation.The SWR graph shown for this product is for a side length of 44 feet as this length provides a lower SWR in the 17 meter band than the 46 foot length. The longer 46 foot length tends to shift the SWR curves to the left (lower frequency) which can sometimes be offset by reducing the length of the ladder line (up to 2 feet max). Each antenna installation is unique – try the antenna lengths as received and shorten the wire length by bending back the wires on themselves at the ends as needed.
Use an antenna tuner for 80, 30, 15 meters and reduce power if balun saturation occurs.
FREE USA Shipping on orders over $100
Insulators may be black, grey or white depending on stock at hand when order is placed. Wire is stranded, AWG#14, insulated and black or grey color.
Super-Choker™ Common Mode Feed Line Chokes
Excellent features:
*** Covers 40-20-17-12-10 meter ham bands under 2:1 at most heights no tuner required, 80, 15, 6 meter bands require wide range tuner
*** Great digital/FT8 antenna on many bands without tuner
*** Low SWR on many bands or use antenna tuner
*** 500 watts/1.5KW/5KW PEP (SSB-ICAS) options
*** Stainless Steel hardware for long life
*** Halyard Hoist hole for ease of center support installation or hang at ends only
*** Insulated #14 wire for durability
*** High Strength insulators (may be black, white or gray)
*** Ladder Line to 1:1 Balun (Note 1500/5000 Watts CUBE Balun can be mounted to a wall, 500 watts MB-1-500 is supported by ladder line
Super convenient and quick – great for contest operation! Choose 500, 1500 or 5000 watt PEP (use 5KW model for digital modes over 1000 watts).
INSTALLATION
For best results support center at 30+ feet and ends over 15 feet. Angle of feed each side must be great than 45 degrees or 120 – 180 degrees total between each side preferred. Any length of 50 ohm feed line ok (from the matching unit) but longer feed lines over 50 feet may show reduced SWR on some bands due to losses in feed line and soil conductivity, nearby objects, etc. Due to local ground conditions, antenna height and feed line length, SWR may vary from samples shown and an antenna tuner may be required or some bands to bring SWR at end of feed line to acceptable levels.
Antenna Length Note:These antennas are shipped from the factory with each side at 46 feet long (92 feet total) so that you may adjust(shorten) the length for your personal installation.The SWR graph shown for this product is for a side length of 44 feet as this length provides a lower SWR in the 17 meter band than the 46 foot length. The longer 46 foot length tends to shift the SWR curves to the left (lower frequency) which can sometimes be offset by reducing the length of the ladder line (up to 2 feet max). Each antenna installation is unique – try the antenna lengths as received and shorten the wire length by bending back the wires on themselves at the ends as needed.
Use an antenna tuner for 80, 30, 15 meters and reduce power if balun saturation occurs.
FREE USA Shipping on orders over $100
Insulators may be black, grey or white depending on stock at hand when order is placed. Wire is stranded, AWG#14, insulated and black or grey color.
Sometimes you need a high power common mode choke that is super effective and the Super-Choker™ products fill this need very well. All Super-Choker™ chokes use multiple turns through ferrite cores for higher choking impedance compared to our multi-bead sleeve chokes which only use one turn through multiple cores. Different ferrite mixes and turns ratios are used to optimize choking impedance in the selected product frequency range.
Super-Choker™ chokes are manufactured with 1/2″ 52 ohm coax cable (rated for full amateur radio legal limit of 1500 watts continuous (or the capacity of the coax cable at the selected frequency – good for over 5KW on 4 MHz into a matched load for example) with PL-259 connectors that can be connected to your coax feed line with simple double female barrel connectors.
Super-Choker™ chokes are ideal for high power stations and are very effective for keeping common mode current off the feed line on verticals, dipoles, and loop antennas at their feed point and also for choking coax lines at the station input to reduce common mode noise picked up by the outside of the coax braid between the feed point and the station entrance.
Ferrite core kits are available separately if you want to supply your own coax feed line.
Super Choker™ Case History:
I run an 80 meter loop antenna about 30 feet in height and have previously been using a coaxial balun common mode choke of 25 turns of RG-213 on a 6 inch form attached about 6 feet under the corner feed point of the loop (configured in a triangle). Using a Dentron 3000 antenna tuner I was able to tune all the ham bands and the lowest SWR was about 1.4 on most bands. The antenna feed line was led away from the corner of the loop and was not under the loop. Feed line length was about 105 feet as measured on the Aim 4170-TDR function.
I first placed a Super Choker™ 8010 at the antenna tuner leaving the coaxial balun in place. As I retuned the antenna tuner, the first thing I noticed was that I could now tune down to 1.1:1 on 80, 40 and 20 meters and I could not do that before. The noise level which had been running about S7 on 40 meters during the day had dropped to about S6 on my TS-870 receiver. I was pleased that the reflected power was now almost nil and the noise level was lower.
I then took the next step and replaced the coaxial balun and Super Choker 8010 with a Super Choker™ 16040 in series with a Super Choker 4010 for maximum choking power from 80-10meters. The antenna tuning was about the same but now the SWR was 1.0:1 on 80-10 meters and the noise level on 40 was down to S5. I tuned up on 20, 15 and 10 meters and worked a couple of JA’s and noticed that the noise level on 10 and 15 was not even S1 – something I had not experienced before on the 5 acre plot of land we call home.
What a welcome relief to find such a simple solution to RF feedback I had experienced and I got a lower noise level to boot!
Now to plan that 160 meter loop! I wonder what Krusty ole Kurt would use?
Bob, AK6R