Multi-Ring/Multi-Snap On Combo Pack, Mix 61, RFI Range 200 - 2000 MHz - 14 filters
| Quantity | Price per item | Discount |
| 2 items | $89.95 | 5% off |
| 10 items | $79.95 | 16% off |
This ferrrite Multi-Ring/Multi-Snap-On Combo Pack is a convenient solution for troubleshooting RFI/EMI (200 - 2000 MHz) with various diameter cables ranging from 1/4" to 1.4"/35.6mm for use as either single turn or multiple turn RFI filters using ferrite rings and snap-ons.
The filters are useful for RF coax, AC/DC power cables, and device interconnection cables. This frequency range is used in switching power supplies, variable speed motors, LED light dimmers and many other DC control circuits. Use on inputs and outputs of these devices to reduce or eliminate RFI.
Always use a snap on or ring with a larger inside diameter than the diameter of the cable and use multiple turns if possible (2 turns through the snap on is the same as 4 snap ons with 1 turn). Included in these combo packs are our most popular snap on sizes as follows:
Combo Pack includes the following:
F240-61 ring – 1.4″/35.6mm ID – 4 pieces
FSB61-1/4 – 1.4"/6.3mm ID – 6 pieces
FSB61-1/2 – 1/2″/12.7mm ID – 4 pieces
Normal Retail price is $106 for these parts - buy more than 1 set and save even more!
Use multiple turns thru the center for best results.
SLIP-ON FERRITE BEADS
Baluns are used to connect balanced antennas to unbalanced transmission lines (Coaxial cable) and Ununs are used to connect unbalanced transmission lines to unbalanced transmission lines or unbalanced antennas (e.g. verticals). In the case of 1:1 baluns the input is usually an unbalanced coax cable and the output load is a two terminal balanced load like an antenna. Ununs are also called line isolators, feed line chokes, and 1:1 coaxial baluns (incorrectly). 1:1 Baluns and ununs stop common mode currents (flowing on the outside of the coax braid due to skin effect) when they are located at the antenna feedpoint. They can also be used as “line isolators/chokes” anywhere along the cable to suppress flow of induced RF (antenna near field radiation and neighborhood noise pickup) which helps suppress RFI into the radio receiver/transmitter. For best results, put one at the antenna feed point connection, and one at the radio room entrance, and for difficult common mode current cases, one every 1/4 wavelength along the antenna feed line. For low (below 3 MHz) frequencies, use two 5 bead baluns in series to double the choking impedance or order the 10 bead or 15 bead version for higher choking power.