5000 Watt rated 1:1 CUBE UNUN™
This higher power UNUN utilizes mil-spec coax cable for the windings on a extra large core toroid with coax silver shield and silver braid for low loss. The dielectric is Teflon® insulation for high voltage ratings of 1,900 volts. (A typical 5KW signal at 50 ohms impedance will have a voltage of 500 volts at 1:1 SWR). Wired as a UNUN (CU-1-5000) with SO-239 input and output connectors. Rated 5KW PEP/1500 Watts AM/RTTY/CW from 1.8-30 Mhz, less at 50 Mhz.
If you run RTTY contests or FT8 at 1500 watts output, this is the balun/unun you need – it won’t burn out at heavy 1500 watt duty cycles like other brands rated at 1500 watts (or more). We use these same chokes in our own RTTY station at full 1500 watts output and they have never failed. We use one at the amplifier output and another at each antenna feed point. Works very well on OCF antennas below the 4:1 balun to keep RF current on the antenna and off the feed line. Built like a tank, works like a charm, and priced under the competition – what more can you ask for? THIS IS OUR MOST POPULAR HIGH POWER UNUN!
Choose optional ground lug (on input connector shield) and static bleeder (on input connector center conductor) to bleed off static charges on a continuous basis. (Not a lightening arrestor)
50 ohm coax to 75 ohm balanced output baluns are useful for low (< 1 wavelength) dipoles exhibiting 75 ohm characteristic impedance or for matching to balanced ladder line whose endpoint impedance is near 75 ohms.
50 ohm coax to 75 ohm CATV coax connections are easily done with a 1.5:1 unun with SO-239 connectors on input and output. Likewise 50 ohm coax to unbalanced verticals or loads near 75 ohms can be matched with a 1.5:1 unun.