The RFI-SMPS is a common mode noise reduction filter set which filters both the AC input and DC output of common SMPS power supplies. These filters effectively isolate the AC power cord and DC output cable from acting as antennas for the internal switching power supply generated noise. The mix 75 filters suppress RFI fundamental frequencies (and the harmonics also) from 150 KHz to 10 MHz. Simple to install on cables without any device modification.
Used for amateur and commercial radio transceiver power supplies, cable TV boxes, laptop computers, or any electronic device powered by an external switching power supply.
We specify impedance ratios as an output to input ratio where the output (or load) is given first and the input is given second (e.g. 100:50 (2:1) would mean a 100 ohm output and a 50 ohm input; a 25:50 (1:2) would mean a 25 ohm load and a 50 ohm input). Most all products use a 50 ohm input unless otherwise specified.
We have products that are available as kits for the do-it-yourself (DIY) person or fully assembled and tested units for the “Plug & Play” crowd.
Our impedance transformers are available using two different topologies: Binocular cores or toroid cores with multiple turns for increased effectiveness and wide band frequency transformations. We utilize single and multiple core transformers using high order windings when needed to extend product performance.
We rate the power ratings as watts PEP (Peak Envelop Power) with standard duty cycles for various modes. To determine the PEP rating required for your needs, see: Choke & Transformer Power Ratings
This website page serves as a link page to the frequency ranges of our impedance transformers configured as either baluns or ununs. You can click on a picture to go to the specific page about the products described in the picture.