The RFI-INVERTER is a common mode noise filter set which filters both the DC input and AC output of DC-AC inverters. These filters effectively isolate the DC power cord and AC output cable from acting as antennas for the internal switching power supply. The filters suppress RFI from 150 KHz to 10 MHz. Simple to install on cables without any device modification. DC filter is a ring and AC output filter is a snap on with 1" inside diameter hole.
For larger cables use the ACCF-3 and DCCF-3 ring filters with 3" inside diameters and use multiple turns on each cable for best results.
AC power strip shown in picture NOT INCLUDED - this is user supplied and shown for illustration of filter installation.
Also make sure you connect a good RF ground to the transceiver ground post.
Note to Flex Radio users: Use snap on ferrites for firewire cable, speaker cable and mic cable, Ring ferrites for Antenna output and DC power.
For additional RFI suppression, use a feed line choke at the antenna to suppress common current on the coax feed line – see our store for feed line choke alternatives for use at the antenna.
If you use a linear amplifier we have RFI kits for linear amplifiers that help suppress RFI in your shack or in your neighbor’s house.