Coax Jumper Choke - RG-400 - RFI Range: 1.8-65 MHz, -30 dB Noise Reduction, 5KW PEP, Antenna Switch/Tuner/Amp/Radio Isolator, Antenna Choke
Product Details
MPN: JC-1-1500
Country/Region of Manufacture: USA
Coax Jumper Choke — RG-400, 5 kW PEP (HF 1.8–65 MHz)
Plug-in feed-line choke that stops common-mode current on the outside of your coax. Use it at the antenna feed point or the radio end to lower noise, reduce RF in the shack, and stabilize your pattern.
HF 1.8–65 MHz RG-400 jumper form factor ~30 dB class reduction (typical) 5 kW PEP
What it fixes
Common-mode current rides the outside of the shield. The jumper choke presents high choking impedance to stop that current—lowering received hash and RF-in-shack.
- Lower noise floor / calmer waterfall
- Less mic/tuner bite and fewer USB/ground gremlins
- Cleaner pattern—coax isn’t part of the radiator
Where to place it
- Best: right below the antenna feed point
- Also: at station entry/radio end; or mid-run as a line isolator
Specs
| Range | HF 1.8–65 MHz (model dependent) |
|---|---|
| Suppression | ~30 dB class typical (installation dependent) |
| Power | 5 kW PEP (SSB ICAS), (mode dependent) |
| Form factor | RG-400 jumper |
Duty cycle: Ratings are SSB PEP. For high-duty digital/CW, SWR > 2:1, or long key-down, reduce average power or step up rating.
On Sale
RG-8X Coax Jumper Cable with PL-259's on each end - 3 feet
RG-8X Coax Jumper Cable with PL-259's on each end - 3 feet
SKU RG-8X-3
List price $19.95
Save 25%
$14.95
DO NOT USE THIS PAGE