Full Wave Loop Antenna Wire Kit for vertical or horizontal loops (square, rectangle or delta shaped) from 160 meters to 10 meter. Includes end insulators, #14 Insulated stranded copper wire and spade lugs for attachment to an optional balun
Insulators are a very stealthy, strong, 4 PVC, 2 1/4" long. 1" wide. 1 1/8" hole separation wire antenna insulators and may be black, gray or white depending upon inventory.
Typical size id 1005/F(MHz) and cut for lowest frequency in band segment.
For multi-band capability use 4:1 balun such as our Bullet-4BEB-500/1500 or CB-4-1500EB/5000EB with a feed line choke below it or best bet is to use the Hybird 4:1 + 1:1 balun, CB-4-1-1500. For single band use a 2:1 balun such as a Bullet-2B-500/1500 or CB-2-1500/5000EB. with a feed line choke below it or the hybrid CB-2-1-1500EB with built in 2:1 and 1:1 balun.
4:1 impedance transformers (Baluns and Unun configurations) are available in kit form or assembled form in a weatherproof Current Unun and Balun Enclosure which we call CUBE Baluns™ and CUBE Ununs™. All 4:1 impedance transformers use ferrite cores and the kit forms can be configured as a balun with balanced output of 200 ohms or as ununs with one side grounded.
4:1 baluns are designed for 50 ohm unbalanced (coax) input to 200 ohm output (either balanced or with one side grounded).
4:1 Baluns are useful between balanced lines for center fed Zepps, Off-center fed (OCF) dipoles with coax, G5RV antennas, full wave loops, NVIS dipoles that are close to ground and have impedance levels near 200 ohms or high impedance feeds for log periodic beams.
4:1 ununs are useful between coax and vertical antennas, monopole verticals or long wires with load impedances near 200 ohms.