Typical user comment:
The filter was quite effective. Was surprised that it actually reduced the noise level more than the signal so S+N/N improved by 1.9 S units. Bill
RFI/EMI Solutions from KHz to GHz
Purpose. The CMNF-500-75F is used to suppress RFI noise and common mode interference on the coaxial feed line of beverage, EWE, and other receiving/transmitting antennas using RG-8 or similar 75 ohm coax feed lines.(also available for 50 ohm lines as CMNF-500-50)
The filter is designed to have a high RF impedance to noise and interference from common mode currents on the outside of the coax braid while passing RF signal currents on the center conductor and inside of the coax braid to the antenna.
The effectiveness of the filter is dependent upon the amount of common mode noise encountered on the feed line. If your receive system has a large amount of common mode noise current then you should experience a reduction of common mode current which usually as heard as background noise level. Typical choking impedance is shown in the gallery picture.
Got Common Mode Noise? Not Sure - Find out now by clicking link below:
Typical user comment:
The filter was quite effective. Was surprised that it actually reduced the noise level more than the signal so S+N/N improved by 1.9 S units. Bill