Audio RFI Eliminator for XLR cables - Triple in line filtering, male/female extension
Suppresses radio frequency interference (noise) on balanced audio lines using triple filtering with:
¨ Shielded cable protection
¨ Inductive Ferrite Filter
¨ Capacitive Filters between audio lines and ground
¨ Effective for RFI from 1-300 MHz
Use for interference from AM/FM broadcast transmitters, wireless mic, and noisy power supplies. Install in series with cables for mic, line, amp/preamp interconnects, and speakers.
Standard cable length is 3 feet.
AM broadcast transmits on a low frequency with large antennas. Consequently it takes a large antenna to receive the signals. Typical “antennas” are AC house wiring, phone lines, long satellite or cable TV cables, DSL/CAT5 lines running between rooms, etc. The device wires that connect to these “antennas” need to be choked with as many turns through the ferrite as possible. Some installation examples are shown below on this page.
For AC/ DC power cords and coax cables the F240-77 (2.4″ OD, 1.4″ ID) “Donut” toroid is the most popular. Also available are smaller toroid donuts and Mix 77 beads. Shown below is a graph with 8, 10, and 12 turns through the toroid – obviously more turns has higher choking impedance. Mix 77 toroid products are HERE and Mix 77 small beads (for small wires) are HERE
Shown below is a graph of frequency response verses choking magnitude for a F240-77 in the AM Broadcast band for a 12 turn coil around the toroid. (Same info as above but different frequency range).
Typical Installations for Donut/Ring Toroids
Extra Mix 75 Snap On Beads HERE – VERY effective for AM Broadcast RFI