5:1 Baluns/Ununs

5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)

Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.

Typical application:

CU 5 1500 antenna - 5:1 Baluns/Ununs

Also available as a balanced output – CB-5-1500

80-10 Meter Loop Antenna System with 4:1 Balun and Choke Combo, 3-30 MHz, 500/1500/5000 PEP Option

PAL-LOOP8010-500
$199.95
In stock
1
Product Details
MPN: PAL-8010LOOP-500, -1500, -5000
Country/Region of Manufacture: USA
Input ohms/Output ohms: 50 in/200 out
Frequency Range < 2:1 SWR (MHz): Balun rated at 1.8-61 MHz for 1.5KW, 1.8-31 MHz for 3KW/5KW
PEP Power Rating (watts): 500W/1.5KW/5KW
Input Connector: SO-239
Output Connector(s): Eyebolts/Wing Nut
Hardware Type: Stainless Steel
Enclosure Size: 4"x4"x 2"(1.5KW), 4"x 4" x 4"(1.5KW/5KW)

80-10 Meter Loop antenna (288' wire) + 500/1500/5000 Watt PEP rated 4:1 Current Balun + internal 1:1 Current Balun in one enclosure + 6 insulators for support

* Complete package - just add coax

* works multiple bands with ease

* can be configured as delta, square, rectangle or multi-sided horizontal loop (6 insulators included)

* Choice of 500, 1.5K, or 5KW PEP rated baluns to suit power needs

* No need for extra feed line choke as it is built into the 4:1 balun enclosure

After many requests we have created a compact, special balun for OCF and loop (Skyloop or Delta loop) antennas. The CB-4-1500OCF is a CUBE enclosure containing a multi-core, broadband 4:1 impedance transformer in series with a 1:1 current balun for extra common mode current choking to keep RF current off the outside of the coax braid and on the antenna where it belongs. The extra choking action also means that the coax feed line will not act as a radiator causing unnecessary RF interference (RFI).


1500 watt is in 4" x 4" x 2" enclosure and 5KW is in 4" x 4" x 4" enclosure.

ADD MC-1-3000 Choke for radio end of coax to reduce common mode noise on coax up to 6 "S" units!

Save this product for later