5:1 Baluns/Ununs

5:1 CUBE™ Unun – Model CU-5-1500 (50:250 Ohm, 1.8-61 MHz, 1.5KW PEP)

Application. For traveling wave, end fed or portable 20-31 foot vertical antennas the 5:1 unun makes a good transformer for converting 50 ohm coax to a 250 ohm feed point. If you use the antenna on multiple bands, the feed point impedance may not always be 250 ohms and use of the unun at high (>350 ohms) or low (<100 ohms) will require reduced power input or the unun may have its power ratings exceeded and damage to the unun may occur. The (5:1 conversion ratio will change for loads other than 250 ohms unbalanced.

Typical application:

CU 5 1500 antenna - 5:1 Baluns/Ununs

Also available as a balanced output – CB-5-1500

2945175589 - 5:1 Baluns/Ununs
+3

Coax Jumper Choke - RG-8X - RFI Range: 1.8-65 MHz, -30 dB Noise Reduction, 1.5KW PEP, Magnetic Loop, Antenna Choke

JC-1-1500-3
$29.95
In stock
1
Product Details
MPN: JC-1-1500
Country/Region of Manufacture: USA

Simple Jumper Feed Line Choke

The simplest, most cost effective feed line choke is a ferrite ring installed as shown in the picture (at the antenna feed point) to stop feed line radiation or at the radio end of the coax to suppress common mode coax noise current on the coax braid.

Improves antenna pattern by preventing your dipole from becoming a tripole

Suppresses pesky coax braid radiation and RFI

Reduces coax braid common mode current up to -30 dB ( 6 "S" units) on receive

Use one choke for each antenna feed line

Add a double female barrel connector to act as an "extension" of the existing coax.

Magnetic Loop Users: use 1 JC-1-1500 at the antenna feed point to keep all of transmit power on antenna and another at radio end to remove common mode noise received on the coax braid.

Need the ring only and not the jumper, select F240-31-1 as the part #.


Save this product for later
Display prices in: USD