Antenna Products

Coax Static Bleeder, Bulk Pack of 10

In stock
Product Details
Brand: Palomar Engineers
UPC: Does not apply
Type: NEW
Country/Region of Manufacture: United States
: 10
: 10.95

Ten pack of Model SB-1, a static bleeder meant for 50 or 75 ohm coax line. It is rated from 1-150 Mhz at 1.5KW with a maximum SWR of 5:1 on the line. The bleeder is used on a coax “T” in line with the coax transmission line as shown in the picture below.

20141004 125359 300x168 - Antenna Products

SB-1 Coax Static Bleeder installed on coax “T” connector

To use procure a coax “T” and a male to male connector. Connect the SB-1 to the male to male connector and thence to the coax “T”. Static voltages are bled off from the center conductor to the outside conductor (braid of the coax). At the entrance to your radio station ensure that the outside conductor of the coax transmission line is grounded so as to provide a sink for the static electricity on the antenna center conductor.

The SB-1 static bleeder is usually installed near the radio shack entrance on the antenna side of any 1:1 baluns/line isolators.

The connector is a male PL-259 and will fit into a SO-239 (female) or "T" with female counterpart to the PL-259. Small, convenient, effective and easy to install!

"T" connector shown in picture NOT included.

Save this product for later
Palomar antenna products include feed line chokes, feed line to antenna matching transformers, static bleeders and other accessories. Click on the link to connect to the product you need.