Store

Solar Power Optimizer/PV Module Noise Filters (2) - ID=1.4"

RFI-PV-PO

Solar Power Optimizer/PV Module Noise Filters (2) - ID=1.4" RFI-PV-PO

The RFI kit is designed to suppress RFI caused by Solar micro-inverters, power optimizer, and solar arrays by electrically isolating the “antenna” wires used to connect the various devices.The cabling between the PV array, the micro-inverters or power optimizers and their connection to the electrical bus combining their individual outputs can be considered “antennas” for the pulse switching circuits of the individual devices thereby causing radiation at very low fundamental frequencies with harmonics that can cause undesirable radio interference in the 1-30 MHz (and sometimes higher) frequency range.This interference may be objectionable to the owner of the solar installation as well as neighbors who may also experience the interference to their electronic devices.

Power Optimizer RFI

Ferrite cores (snap on) are snapped over the two (+/-) cables from the solar array module and the two wires hooked to the “string” connecting the optimizers together. Suppressing RFI on all wires in and out of the optimizers helps to reduce any broadband RFI “noise” generated in the SOURCE switching circuits (typically at 20-500 Khz and harmonics thereof). Two ferrite filters are required for each optimizer – we recommended Part # PV-RFI-PO (includes two ring filters). See typical installation diagram below:

Power Optimizers with filters 2 png - Store

$20 In stock
UPC:Does not apply
Brand:palomar Engineers
MPN:RFI-PV-PO
Type:New
Country/Region of Manufacture:United States
Filter Power Rating (PEP watts):not applicable
RFI Suppression Range (MHz):.1-50
Enclosure Size (inches):none
Solar Power Optimizer/PV Module Noise Filters (2) - ID=1.4"